Finding Parallels Between Lights and Life

Crown Molding and Pot Light Installation Tips and Tricks

Crown molding and pot lighting installation can be done DIY using the proper tools and equipment, and having the right skills, but it can also be intimidating because walls are not always flat and nailing can be difficult. What makes an aesthetically appealing crown molding? In this article, we will be focusing on a project combining standard crown molding with two-pieces of mold base trim. It is a good idea measuring the length of the wall for the crown molding so you can buy pieces that are long enough to span each wall, and to prevent scarfing pieces together. Choose the same tone if you want to use a light-colored stain, and crown molding can be installed using a hammer, handsaw, and miter box. We highly advised using brad nailer and miter saw for faster work.

You can easily combine crown molding with other trim for a richer look. Using a one-piece crown, it can be messy because you might need ailing blocks or glue, so it is best to have a built-up crown to eliminate the frustrations associated with nailing, dealing with trouble spots easily as you install the rail trim, having a continuous and solid base to nail the crown. You need to chalk lines in order to have the right position for the rail trim, marking at ceiling joists and studs so you will know where to drive the nails, and most carpenters draw lines and marks on the walls and ceiling, then just hide them with paint. An easier method is sticking bands of 2 inches wide masking tape to the ceiling and walls. Tape will not stick properly if the walls or ceilings are just newly painted, so you need to wait for a couple of weeks before using tape. Now, you can install the trim over the masking tape, and leave it in place to protect your ceiling and walls when you paint or apply a finishing coat. When it comes to the actual trim placement, add the piece to the right next to the first piece in place, and work around the room in that direction, so in that way, you will make most of your 45-degree cuts using a miter saw. You can use a construction adhesive on the rail to use just enough nails to hold the trim in proper position until the adhesive sets, with fewer nail holes to fill.

Remember that you need to miter your ceiling rails both exterior and interior corners, and test the pieces to determine the exact angle. Miter wall rails at outside corners and the inside corners are coped, wherein wall coping is like coping a crown except that you need to stand the trim upright against the fence of the saw when you are making the 45-degree miter. Crown molding and pot installation can be challenging for a first timer, so if you don’t have time to do it, contact a professional to help you out. You can check the best crown molding and installation companies and get real reviews now!Learning The Secrets About Installations

On Resources: My Rationale Explained